OK here is something new. If you're a Star Wars fan and a Ham Radio operator this is a most have.
This is 7" H 7.5" W 7.5L. PLA 3D print of the Seeker Droid. This Hotspot is built with a Pi 3 B+ board and a duplex MMDVM Duplex board with built on board antennas. Remember this is not a toy for you to play star wars games with all your Star Wars club, it is a Hotspot for Digi modes.
Here is the run down:
The Raspberry Pi 3 Model B+ is boasting a 64-bit quad core processor running at 1.4GHz, dual-band 2.4GHz and 5GHz wireless LAN, Bluetooth 4.2/BLE, faster Ethernet, and PoE capability via a separate PoE HAT.
The dual-band wireless LAN comes with modular compliance certification, allowing the board to be designed into end products with significantly reduced wireless LAN compliance testing, improving both cost and time to market.
The Raspberry Pi 3 Model B+ maintains the same mechanical footprint as both the Raspberry Pi 2 Model B and the Raspberry Pi 3 Model B.
SPECIFICATIONS
- 1.4GHz 64-bit quad-core ARM Cortex-A53 CPU (BCM2837)
- 1GB RAM (LPDDR2 SDRAM)
- On-board wireless LAN - dual-band 802.11 b/g/n/ac (CYW43455)
- On-board Bluetooth 4.1 HS low-energy (BLE) (CYW43455)
- 4 x USB 2.0 ports
- 300Mbit/s ethernet
- 40 GPIO pins
- Full size HDMI 1.3a port
- Combined 3.5mm analog audio and composite video jack
- Camera interface (CSI)
- Display interface (DSI)
- microSD slot
- VideoCore IV multimedia/3D graphics core @ 400MHz/300MHz
- OLED On Base
With the ARMv8 processor it can run the full range of ARM GNU/Linux distributions, including Snappy Ubuntu Core, as well as Microsoft Windows 10 IoT edition.
Duplex MMDVM Hotspot UHF/VHF P25 DMR YSF D-Star M17 plus more. Running Raspberry Pi 3 B+ with OLEDRunning Pi-Star: 4.1.8 (Latest version)Raspberry Pi 3 B+Pi-Star loaded on SD card you just need to configure your call and Wi-Fi and other info than you're on the air.Features:-Duplex Hotspot Seeker Droid -High performance 32-bit ARM processor-Supports DMR, P-25, D-Star and System Fusion M17-Fully tested-Antennas Built onboard nothing sticking out
-OLED on Base
WIDELY COMPATIBLE: Supports DMR, P-25, D-Star and System Fusion M17Differences in Duplex and Simplex: In Duplex mode, have 2 time slots, and Tx and Rx can do at the same timeRadio Frequency: In duplex mode, support 430-440 uhf, in simplex mode support both uhf 430-440MHz and vhf 140-150MHzBest adjusted: TX =0, RX=0 need no offset.Modem select: STM32-DVM/MMDVM_HS-Raspberry pi Hat(GPIO)3D Silver, Blue Printed Case: For high RF performance over metal case.Antenna: On board two antennas 1=TX 1-RX